MAXXTOW 70070 - Setting Up the Dual Hitch Extension; Securing the Shank to the Receiver Hitch; Securing Towed Trailer and Accessories; Adherence to Manufacturer Instructions

1. A 5/8” diameter steel hitch pin and match-
ing R-Shaped Safety Clip (both not included)
are needed to secure the Dual Hitch Exten-
sion’s shank to the tow vehicle’s receiver
hitch - see illustration below.
Insert shank so that lower receiver (with col-
lar) is in downward position (this is for tow-
ing). The upper receiver, with no collar, is
for attaching accessories and should not be
used for towing.
2. The shank of both towed trailer and at-
tached accessories must be secured to the
Dual Hitch Extension with similar hitch pins
and R-Shaped safety clips as described
above. Hitch pins and safety clips are not
included. Make sure safety clips are always
fully engaged.
3. Read and adhere to all safety warnings
and instructions provided by the manufac-
turer of the receiver hitch and the trailer/ac-
cessory being towed.
4. Do not exceed the maximum weight rat-
ings shown in the specication chart on
cover page of this manual.
Model 70070 Page 4
Setting Up the Dual Hitch Extension
Hitch Pin
R-Shaped Safety Clip
Dual Hitch
Extension
Shank
Always wear ANSI approved
safety goggles.