To Next PageTo Next Page
Need help?Do you have a question about the Mayne Nantucket and is the answer not in the manual?
This document provides assembly instructions for the Nantucket & Winchester address signs, identified as #MIS005. It covers general information, a materials list, hardware pack contents, tools required, and step-by-step assembly instructions.
The manual emphasizes the importance of reading instructions carefully before beginning assembly and identifying each component from the materials list. Users are advised not to use excessive force during assembly to prevent damage. For cleaning, a soap solution and high-pressure water are recommended. In case of missing or defective parts, customers can contact Mayne's customer service at 1-866-363-8834.
The primary component is the "Decorative Address Sign" (Part #1), which can be either the Nantucket or Winchester style. Only one sign is included.
To complete the assembly, the following tools are necessary:
The first step involves inserting a 4x4 wood post (Part #5, not included) into one of the holes in the address sign. Approximately 20 inches of the post should extend from the bottom of the sign. The post is then secured to the sign's base using a 3-inch screw (Part #2) through each side, as illustrated in the diagram. Users are cautioned not to overtighten the screws, as this could cause the plastic to dimple or crack. This process is repeated for the second wood post. Nylon washers (Part #3) and plastic snap caps (Part #4) are provided to cover the screw heads, enhancing aesthetics and protecting the screws.
Once the sign is attached to the wood posts, it should be placed in the desired location to mark the exact positions where the posts will be installed. After marking, two 20-inch deep holes need to be dug for each post.
The sign, with the attached wood posts, is then placed into the dug holes. The depth can be adjusted as needed to achieve the desired height. A level should be used to ensure the sign's orientation is perfectly straight. Once satisfied with the positioning, the holes are filled. For enhanced stability, especially in areas prone to high winds or heavy traffic, the manual recommends using pre-mix concrete (not included) to secure the posts in the ground.
The manual explicitly states that 4x4 wood posts, pre-mix concrete, and address plaques are NOT included with Mayne address signs.
For any questions regarding assembly, installation, comments, or suggestions, customers can contact Mayne's Customer Service Department at 1-866-363-8834. Support is available weekdays from 8:00 AM to 4:00 PM Eastern Standard Time. Alternatively, inquiries can be sent via email to info@mayneposts.com.
The Nantucket & Winchester address signs are decorative outdoor fixtures designed to display house numbers. They feature a classic, framed design, available in two distinct styles: Nantucket and Winchester. The signs are constructed from durable plastic components, designed to withstand outdoor elements. The assembly process involves securing the plastic sign frame to two 4x4 wood posts (not included) using steel screws, nylon washers, and plastic snap caps. The entire assembly is then installed into the ground by digging holes and backfilling them, with an option for concrete reinforcement for added stability. The product is designed for easy maintenance, recommending a soap solution and high-pressure water for cleaning. The inclusion of various colored snap caps allows for some customization to match different aesthetic preferences. The product aims to provide a distinguished and clear display for residential addresses.
General| Brand | Mayne |
|---|---|
| Model | Nantucket |
| Category | Postal Equipment |
| Language | English |
