CHECKING RINSE AID ENSURING HOT WATER
Regular use of a rinse aid improves drying and For good cleaning and drying results, hot
reduces spotting and filming, water is necessary. The incoming water tem-
perature should be 120-140°F to properly
Your Maytag Jetelean TM dishwasher features an auto- activate the detergent and melt greasy food
matie rinse aid dispenser located near the detergent soils.
cups in the door.
If for any reason (such as laundering, showers, etc.) the
The clear window in the center of tile dispenser cap incoming water temperature is below 120°F (49°C),
allows you to see if there is rinse aid in the reservoir, select the Terap Sense option to have the dishwasher
When the window is colored, there is rinse aid in the thermostatically heat the water to proper temperature.
dispenser. When the v4ndow becomes clear, it is time
to refill the dispenser. (As a guide, cheek the dispenser To check the incoming water temperature, turn on the
monthly.) hot water fhucet nearest the dishwasher and let it run
into a glass in the sink. Place a candy tllermometer in
.... _ the glass and check the temperature once it has stopped
rising. If the temperature is below 120°F (49"C), have a
qualified person raise the water heater thermostat set-
ting.
iv
Before starting the dishwasher, turn on the hot water
faucet and let it run until the water is hot.
To add rinse aid to the dispenser, turn t:he cap counter-
eloeGvise to open. Remove the cap and pour liquid
rinse aid into the opening. Replace the cap and turn it:
clockwise.
An adjustable cap found on some models allows you to
adjust the amount of rinse aid dispensed. A raised dot
on the cap indicates the recommended initial setting.
Typically, use the LESS setting for soft water and the
MORE setting for hard water. Set the cap anywhere
between these amounts as needed. To improve dwing,
turn the cap towards the MORE setting. When adJust-
ing or replacing the cap, be sure it is securely in place
before closing the dishwasher door.
Page 6
To Next Page
Loading...
