Read this before you start...
TOOLS needed for installation:
• Cutting knife
• Channel lock
• Nut driver
• Level
• Crescent wrench
• Screwdriver-flatblade
Proper installation is the responsibility of the purchaser.
SERVICE CALLS PERFORMED AS A RESULT OF POOR INSTALLATION ARE THE
RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
©
GROUNDED ELECTRICAL OUTLET is required. See Electrical Requirements.
STANDPIPE DRAIN SYSTEM must be able to accept 1 1/2" O.D. drain hose. Standpipe
height of 36" is recommended.
NOTE: Unit is designed to pump efficiently to a height of 8 feet at normal spin speeds.
HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer.
LAUNDRY TUB DRAIN SYSTEMS (for use with Water-Saver Models only). Tub capacity
to hold a minimum of 21 gallons.
WATER HEATER set to deliver 140°F (60°C) hot water to the washer.
PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).
PARTS supplied for installation:
• 2 inlet hoses
• 4 hose washers
• 2 hose screens
• 1 cable tie
• Literature package
INSTALLATION ACCESSORY KITS
Pa_ No.
12001875
12001585
12001586
12001599
211692
204986
Description
Grounding Kit
Drain Hose Extension
Anti-Siphon
Small Diameter Standpipe
Drain Hose
Non-Slip Disc
Carpet Installation Disc
Application
Additional grounding if required by local codes.
Extends drain hose for drain facilities higher than 4 ft.
Used when an air-tight connection exists between
drain hose and drain facility. Floor drain facilities.
Used when standpipe diameter is too small to
receive end of drain hose.
For painted/sloped basement floors.
For carpeted floors.
To Next Page
Need help?
General
