As the lever is moved to the cleaning tools position
the cam locks on to the gate and slides it to shut off
suction to the agitator cavity.
Note: These illustrations are shown without the
bottom plate or wheel assembly in place.
Dirt Finder feature:
The embedded Dirt Finder system is powered by a
regular 9V alkaline battery. The battery is located
in a holder inside the bag compartment.
The circuitry is energized when the cleaner on/off
switch is turned to the on position. A separate
switch mounted in the bag housing is actuated by a
raised rib on the upper switch rod.
A microphone, located near dirt duct, senses debris
that strikes the tube and signals the circuit board
which controls the lights.
The green light signifies clean and the red dirty.
It is important to note that when you turn on the unit
the red light will come on. After a few seconds the
red light will go off and the green light will come on.
This function lets you know the Dirt Finder feature
is ready. If this lighting pattern does not occur
check the troubleshooting portion of this instruction.
III. Disassembly
Models with a bag door skip to section B.
A. Outer bag (Legacy and Legacy II Models)
1. Release jacket support upper from bag strap
(Fig. 1).
2. Release outer bag retention clips (Legacy - 2
upper, 2 lower; Legacy II - 2 upper, the 2 lower tabs
are there but are not fastened) ... grasp bag
attachment collar support area and pull out. (Fig. 2)
3. Remove handle bolt and nut (Fig. 3 & 4).
7
To Next Page
Loading...
