(ONTROlSATAGlAN(f
m QE(T tvtu
INTELLIDRY WRINKLE FREE FABRICS WITH
PRESS CARE
automatically senses the moisture in the
load and shuts off when the selected dryness level is
reached. It minimizes wrinkles in synthetic fabrics such as
acrylic, nylon, polyester or blends by providing an unheated
cool-down period at the end of the cycle. Simply set the con-
trol to the desired dryness level (MORE DRY - LESS DRY).
The line between MORE DRY and LESS DRY is the initial
preferred setting for the majority of loads.
INTELLIDRY
WRINKLE FREE
FABRICS
WITH PRESS CARE
INTELLIDRY REGULAR
automatically senses the moisture
in the load and shuts off when the selected dryness level is
reached. This cycle is designed for loads such as towels, under-
wear, t-shirts, jeans, etc. Set the control to the desired dryness I
level (MORE DRY - LESS DRY). The line between MORE DRY
and LESS DRY is the initial preferred setting for the majority of
loads.
INTELLIDRY
OFF
MORE DRY
REGULAR
0 TIME DRY/
AIR FLUFF
WRINKLE RELEASE
will release wrinkles
from items that are clean and dry but slight-
ly wrinkled, such as from a crowded closet,
packed suitcase or from sitting in the dryer
too long after the end of the cycle. It provides
10 minutes of heated tumbling and 5 minutes
of cool down tumbling without heat.
DAMP DRY
is designed to “partially” dry
items. It provides approximately 20 minutes
of heated tumbling and 5 minutes of cool
down tumbling without heat.
TIME DRY/AIR FLUFF
may be
selected for any load if the IntelliDry
DRYEL FABRIC CARE
is designed for
use on dry clean only fabrics in combi-
nation with Dryel Dry Clean Only Fabric
Care product. Placing the control dial
arrow at the DRYEL line will provide the
optimal amount of time needed to prop-
erly use Dryel. (For more information on
using the Dryel cycle, see page 7.)
sensor system is not used. Set the
controi to the desired number of min-
utes and choose the appropriate dry-
ing temperature for the load.
NOTE: The dial can be turned in either direction to select a cycle. Once started, the dial will not advance at a specific rate
during the IntelliDry cycles. At first the dial may not advance at all, Toward the end of the cycle (when the load begins to
dry) the dial will advance at a more regular rate and much more quickly This is normal operation.
WRINKLE RELEASE
DiMP DRY
To Next Page
