- Functioning of brake system, also parking brake
It is necessary to check daily:
- Fluid level in washer of wind shield;
To check air pressure in tires at the necessity
Works performed once per two weeks (on returning from trip, on the base):
-To check the presence of oil leakage, fluid from engine, gear-box, driving axles, steering wheel, heating system, shock absorber of
suspension, hydro cylinders of hoisting mechanism of cab and platform;
-to check the fluid level in the tank of drive of clutch control;
- to check the absence of condensate in receivers at the temperature of environmental air close to 0
0
;
- in case of engine start-up difficulties be electrical starter to make maintenance of accumulator batteries following attached operation
manual;
- to check free movement of steering wheel, the absence of clearances in steering links
- (nutation of steering wheel)
- To check (once per 2 weeks on returning from trip):
-condition and work of platform hoisting mechanism;
- hermeticity of system of platform hoisting mechanism
Works performed monthly:
-To check functioning of independent fluid heater
First technical maintenance (A)
At the truck maintenance after indicated run of performed works, foreseen by daily maintenance and besides:
1 To check splinting of ball pin nuts of steering links, pins of brake chambers forks and to eliminate defaults
2 To check condition of rubber branch pipes of entrance of engine branch pipe system and to tighten up links at the necessity
3 To make service maintenance of accumulator batteries according to attached operation manual, to check fastenings of accumulator
batteries, to clean them from dust, dirt, and electrolyte tracking, to clean air vents. To check connection of wires tops with clamps. To grease
clamps with lubrication Litol-24.To check and tighten bolt of fastening of electrical wires connection “masses” on side bracket of engine
support.
4 To check rod motion of brake chambers. If rod motion does not meet the size 38-44 мм, to check correctness of adjustment lever
setting and find out a reason of down and remove it.
5. To check and tighten up nut of fastening of platform of truck to the frame to make adjustment of side locks and back side platform
providing proper bearing of side locks to the post pins.
To Next Page
Loading...