Q
CRUISE CONTROL SYSTEM
Inspection
1 . Disconnect the cruise actuator connector.
2. Measure the cruise actuator resistance.
Terminal
Resistance (Q)
FS-ATX
Other
A-C
B-A 55
—
B-C
21
A-B B-D 55
B-C —
110
D-B
—
60
D-C 60
A-D
—
6
3. If not as specified, replace the cruise actuator.
(Refer to page Q-17.)
ACTUATOR CABLE
Removal I Installation
1 . Disconnect the actuator cable from the accelerator
pedal.
2 . Remove the clamp at the inside of the firewall.
3. Disconnect the actuator cable from the cruise actuator.
4. Remove the clamps and the actuator cable.
5. Install in the reverse order of removal.
Q -18
To Next Page
