5-14
Driving Your Mazda
Starting and Driving
Form No. 8Q44-EA-01K
▼
To Set Speed
1. Turn on the CRUISE MAIN switch.
2. Accelerate to the desired speed, which
must be more than 40 km/h (25 mph).
3. Press the lever down to SET/COAST
and release it at the speed you want.
Release the accelerator at the same
time.
Don’t continue to hold the lever. Until
you release it, speed will continue to
drop (unless you continue to
accelerate) and you’ll miss the desired
speed.
▼
To Increase Cruising Speed
Follow either of these procedures.
•
Press the lever up to RES/ACC and
hold it. Your vehicle will accelerate.
Release the lever at the speed you
want.
Your vehicle has a tap-up feature that
allows you to increase your current
speed in increments of 1.6 km/h (1
mph) by a momentary tap of the lever.
Multiple taps will increase your vehicle
speed 1.6 km/h (1 mph) for each tap.
•
Accelerate to the desired speed.
Press the lever down to SET/COAST
and release it immediately.
NOTE
•
The SET function can’t be activated
until about 2 seconds after the
CRUISE MAIN switch has been
engaged.
•
On a steep grade, the vehicle may
momentarily slow down going up or
speed up while going down.
J16L_EA.book Page 14 Friday, February 22, 2002 11:34 AM
To Next Page
Loading...
Need help?
General
