2-15
Essential Safety Equipment
Seats
Form No. 8Q44-EA-01K
4. Raise the reclining lever and lower the
seatback forward.
Make sure the seatback is locked.
5. Work only on one seat at a time to
avoid one seat falling while working on
another.
6. Lift and hold the seat-anchor bar and
raise the entire seat up and forward.
7. The seat is heavier than it looks,
carefully pull up and detach the seat.
Get assistance to lift it out of the
vehicle.
To install the seat
1. First identify which seat fits which
position by verifying that the seat belt
buckles point to the center (inboard) of
the vehicle.
2. Align the clamps on the front underside
of the seat with the forward loop
anchors on the floor and support the
seat so that it doesn’t fall (the rear
portion of the seat cannot be mounted
first). The clamps on the front of the
seat automatically lock into the floor
loop anchors after lowering the seat.
Seat-anchor bar
Loops
Clamp
Loops
Clamp
J16L_EA.book Page 15 Friday, February 22, 2002 11:34 AM
To Next Page
Loading...
Need help?
General
