Fluid Classification Application Capacity
Engine coolant
4
Mazda
green-colored or
yellow-colored
Premium Engine
Coolant
2.0L I4 Zetec
engine with
manual
transaxle
5.0L (5.3
quarts)
3.0L V6 Duratec
engine with
automatic
transaxle
10.0L (10.6
quarts)
Rear axle
lubricant
SAE 80W-90
Premium Rear
Axle Lubricant
4X4 1.4L (2.96 pints)
5
Windshield
washer fluid
n/a All 2.6L (2.7
quarts)
1
Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the dipstick or on the dipstick
handle. MERCONt and MERCONt V are not interchangeable. DO NOT
mix MERCONt and MERCONt V. Refer to your scheduled maintenance
section to determine the correct service interval.
2
Service refill capacity is determined by filling the transmission to the
bottom of the filler hole with the vehicle on a level surface.
3
Indicates only approximate dry-fill capacity. Some applications may vary
based on cooler size and if equipped with an in-tank cooler. The amount
of transmission fluid and fluid level should be set by the indication on
the dipstick’s normal operating range.
4
Add the coolant type originally equipped in your vehicle. DO NOT USE
Extended Life Engine Coolant (orange in color). Refer to Adding engine
coolant in this chapter.
5
Fill to 6 mm to 14 mm (1/4 inch to 9/16 inch) below bottom of fill hole.
For further information on your lubrication specifications, see your
authorized Mazda dealer.
Maintenance and Specifications
268
To Next Page
Loading...
