Black plate (93,1)
CAUTION
l
Install the battery with the positive
pole (
) facing down. Battery
leakage could occur if it is not
installed correctly.
l
When replacing the battery, be
careful not to bend the electrical
terminals or get oil on them. Also be
careful not to get dirt in the
transmitter as it could be damaged.
l
There is the danger of explosion if
the battery is not correctly replaced.
l
Replace only with the same type
battery (CR1620 or equivalent).
l
Dispose of used batteries according
to the following instructions.
l
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
l
Never disassemble.
l
Never throw the battery into fire
and/or water.
l
Never deform or crush.
Replacing the transmitter battery
1. Unfold the key (page 3-2).
2. Insert a small screwdriver into the slot
and push the tab to remove the key
from the transmitter.
Tab
3. Insert a small screwdriver into the slot
and gently pry open the transmitter.
4. Remove the battery.
Knowing Your Mazda
Doors and Locks
3-7
Mazda MPV_8U61-EA-05G_Edition1 Page93
Tuesday, June 21 2005 9:32 AM
Form No.8U61-EA-05G
To Next Page
Loading...
Need help?
General
