EMISSION SYSTEM
01–16–8
QUICK RELEASE CONNECTOR (EMISSION SYSTEM) FUNCTION [LF]
E5U011642692N01
• Quick release connectors that can be easily connected/disconnected have been adopted to improve
serviceability.
End Of Sie
QUICK RELEASE CONNECTOR (EMISSION SYSTEM) CONSTRUCTION/OPERATION [LF]
E5U011642692N02
• There are four types of quick release connectors.
Quick release connector locations
Type A
• An SST is not used with this type.
• Mainly consists of a retainer and O-ring. The quick release connector is integrated with the evaporative hose
and therefore cannot be disassembled.
• When the quick release connector is connected,
the joint port projection is locked at the clamp lock
point. By pushing the clamp release tab to
expand the clamp, the lock point is released
allowing the joint port to be disconnected.
• To connect the quick release connector properly,
push it into the joint port until a locking click sound
is heard.
PURGE SOLENOID
VALVE
FUEL TANK SIDE
ENGINE COMPARTMENT
SIDE
TYPE C
CHARCOAL CANISTER
AIR FILTER
EVAP SYSTEM LEAK
DETECTION PUMP
TYPE A
TYPE A
TYPE D
TYPE B
E5U116ZS5004
QUICK RELEASE CONNECTOR
RELEASE TAB
LOCK POINT
C3U0114S091
To Next Page
Loading...
