EMISSION SYSTEM
01–16–10
Type C
• The connector can be disconnected by pinching
the retainer tab with the SST and pulling the
connector.
• To connect the quick release connector properly,
push it into the joint port until a locking click sound
is heard.
• New quick release connectors are fitted with a
checker tab that prevents improper fit. This
checker tab cannot normally be removed. When
the quick release connector is properly connected
to the connection point, the lock is released and
the checker tab comes off. Due to this, it can be
verified that the quick release connector is
completely connected.
Type D
• Release the locks between the retainer and joint
port by pressing each retainer lock one by one
using a flathead screwdriver or a similar tool.
• To connect the quick release connector properly,
push it into the joint port until a locking click sound
is heard.
SST
E5U114ZW5003
CHECKER TAB
CONNECTION POINT
EPU113ZT4610
FLATHEAD
SCREWDRIVER
QUICK RELEASE
CONNECTOR
C3U0116W153
To Next Page
Loading...
