CONTROL SYSTEM
01–40–14
Traction Control
• The PCM calculates the target throttle valve opening angle by the torque up/down request signal from the DSC
HU/CM and TCM and the engine speed.
Cruise Control
• Calculates the throttle valve opening angle based on the deviation of the actual vehicle speed from the set
vehicle speed which was set with the cruise control switch and sends a duty signal to the throttle valve actuator.
• The PCM controls the actual vehicle speed so that it is close to the set vehicle speed.
• The cruise control includes the cruise control operation condition and the cruise control stop condition.
Cruise control operation condition
• When all of the following conditions are met, execution of the cruise control system is enabled (cruise control
standby status).
— Cruise control ON OFF switch: ON
— Vehicle speed: More than 27 km/h {17 mph}
Cruise control stop condition
• When any of the following conditions are met even while in cruise control, the PCM stops the cruise control and
clears the set vehicle speed.
— Ignition switch: OFF
— Cruise control ON OFF switch: OFF
— Cruise control related DTCs (P0564, P0571) detected
• When any of the following conditions are met even while in cruise control, the PCM stops the cruise control
while storing the set vehicle speed.
— Cruise control CANCEL switch: ON
— Neutral switch (MT) or CPP switch (MT): ON
— TR switch (AT) P/N position switch: ON
— Vehicle speed: Less than 22.5 km/h {13.9 mph}
— Brake switch: ON
— The actual vehicle speed is 15 km/h {9.3 mph} or more lower than the set vehicle speed during cruise
control (ascending).
— Condition where actual vehicle speed is 15 km/h {9.3 mph} or more lower than the set vehicle speed
continues for 60 s or more even when the RES/+ switch is on.
STANDBY
ACCELERATION
TAP UP
DECELERATION
ON OFF
RES /+
RESUME
SET
VEHICLE
SPEED
CLEAR
SET/-
CANCEL
VEHICLE
SPEED
0 km/h
{0 mph}
VEHICLE SPEED
SETTING
TAP DOWN
ACTUAL
VEHICLE SPEED
SET
VEHICLE SPEED
ON
OFF
+
RES
SET
-
CANCEL
STANDBY
E5U140ZW5501
To Next Page
Loading...
