ON-BOARD DIAGNOSTIC [SJ6A-EL]
05–02–4
P0713
Transmission fluid
temperature (TFT) sensor
circuit malfunction (short to
power/open circuit)
• TCM detects ATF temperature of less
than -43 °C {-45.4 °F} when engine is
warmed-up and running.
• Fixes ATF temperature value at 80 °C
{176 °F}
• Inhibits slope mode control
• Inhibits self learning control
P0717
Turbine sensor circuit
malfunction (open circuit/
short circuit)
• Turbine speed signal is not input during
vehicle speed signal 12 pulse period
when driving in D range.
• Substitutes vehicle speed signal for
turbine speed signal.
• Inhibits 5GR and 6GR
• Inhibits self learning control
• Inhibits driver adaptive shift control
P0722
Vehicle speed sensor
(VSS) circuit malfunction
(open circuit/short circuit)
• Vehicle speed signal is not input during
turbine speed signal 12 pulse period
when driving in D range.
• Substitutes turbine speed signal for
vehicle speed signal.
• Inhibits 5GR and 6GR
• Inhibits self learning control
• Inhibits driver adaptive shift control
P0751
Shift solenoid A
malfunction (stuck off)
• TCM detects that shift solenoid A does
not change from off when engine is
running
• Inhibits 4GR, 5GR and 6GR
• Inhibits 1GR and 2GR (manual mode)
P0752
Shift solenoid A
malfunction (stuck on)
• TCM detects that shift solenoid A does
not change from on when engine is
running
N/A
P0756
Shift solenoid B
malfunction (stuck off)
• TCM detects that shift solenoid B does
not change from off when engine is
running
N/A
P0757
Shift solenoid B
malfunction (stuck on)
• TCM detects that shift solenoid B does
not change from on when engine is
running
N/A
P0761
Shift solenoid C
malfunction (stuck off)
• TMC detects that shift solenoid C does
not change from off when engine is
running
N/A
P0762
Shift solenoid C
malfunction (stuck on)
• TMC detects that shift solenoid C doe
not change from on when engine is
running
• Inhibits 4GR, 5GR and 6GR
P0766
Shift solenoid D
malfunction (stuck off)
• TCM detects that shift solenoid D does
not change from off when engine is
running
• Inhibits 4GR, 5GR and 6GR
Shift solenoid G
malfunction (stuck on)
• TCM detects that shift solenoid G does
not change from on when engine is
running
• Inhibits 4GR, 5GR and 6GR
P0781 1-2 shift valve malfunction
• TCM detects 1–2 shift valve
malfunction.
• Inhibits 4GR, 5GR and 6GR
• Inhibits 1GR and 2GR (manual mode)
P0813
Reverse sequence valve
malfunction
• TCM detects reverse sequence valve
malfunction.
• Inhibits 6GR
P0819
Manual switch/up switch/
down switch circuit
malfunction (open circuit/
short circuit)
M range switch circuit malfunction
• M range switch remains on for 2 s or
more except in D range.
• Inhibits manual mode control
Up switch or down switch circuit
malfunction
• When all of the following conditions are
met:
— M range switch off.
— Except D range
— Up or down switch remains on for 10
s or more.
• Inhibits manual mode control using
selector lever
P0826
Steering shift switch circuit
malfunction (open circuit/
short to ground)
• TCM detects short circuit or short to
ground in steering shift switch circuit
when engine is running.
• Inhibits manual mode control
P0882
TCM B+ low (less than 9
V)
• Voltage of less than 9 V detected at
TCM terminals 1AD when engine is
running.
• Emergency mode
• Inhibits self learning control
• Inhibits driver adaptive shift control
• Inhibits TCC control
P0883
TCM B+ low (less than 11
V)
• Voltage of less than 11 V detected at
TCM terminals 1AD when engine is
running.
• Inhibits self learning control
DTC
No.
On-board diagnostic
function
Detection condition Fail-safe
To Next Page
Loading...
