ON-BOARD DIAGNOSTIC [SJ6A-EL]
05–02–8
SIMULATION FUNCTION [SJ6A-EL]
E5U050200000N08
• By using the WDS or equivalent, simulation items for input/output parts preset in the TCM can be optionally
selected and operated regardless of TCM control conditions.
Simulation Item Table
X: Available
End Of Sie
DLC-2 OUTLINE [SJ6A-EL]
E5U050200000N09
• A connector (DLC-2) conforming to International Organization for Standardization (ISO) standards has been
added.
• Shape and terminal arrangement as stipulated by the ISO 15031-3 (SAE J1962) international standard has
been adopted for this connector. The connector has a 16-pin construction that includes the B+, CAN_H,
CAN_L, GND1, GND2 and KLN terminals.
End Of Sie
Simulation
item
Applicable component Unit/Condition
Operation
TCM terminal
IG ON Idle
LPS Line pressure control solenoid A N/A X 1E, 1R
SSA Shift solenoid A On/Off N/A X 1AF
SSB Shift solenoid B On/Off N/A X 1AB
SSC Shift solenoid C On/Off N/A X 1AA
SSD Shift solenoid D On/Off N/A X 1S
SSE Shift solenoid E On/Off N/A X 1V
SSF Shift solenoid F A N/A X 1O, 1Z
SSG Shift solenoid G A N/A X 1L, 1Y
TCCC TCC control solenoid A N/A X 1D, 1Q
Terminal Function
B+ Battery power supply terminal
CAN_L Serial communication Lo terminal
CAN_H Serial communication Hi terminal
GND1 Body ground terminal
GND2 Serial communication ground terminal
KLN Serial communication terminal (malfunction diagnosis use)
B+
CAN_L
GND1
CAN_H
GND2
DLC-2
KLN
D6U502BS7004
To Next Page
Loading...
