AUTOMATIC TRANSMISSION SHIFT MECHANISM
05–14–2
KEY INTERLOCK SYSTEM OUTLINE
E5U051409000N01
• The key interlock system, which is composed of the interlock cable and steering lock, prevents the ignition
switch from being removed when the selector lever is in any position other than the P range. (The ignition
switch cannot be turned to the LOCK position.)
End Of Sie
KEY INTERLOCK SYSTEM OPERATION
E5U051409000N02
Positions other than P position (Key interlock is operating)
• When the selector lever is in a position or range
other than P position, the cable end is set at the
key-locked position. When the engine is switched
off and an attempt is made to turn the ignition
switch to the LOCK position, turning of the cam is
restricted by the slider because the cable end
pushes the slider to the cam side, and the ignition
switch cannot be turned to LOCK.
P Position (Key interlock is not operating)
• When the selector lever is in P position, the cable
end is at the key-unlocked position, and because
the slider does not restrict movement of the cam,
the ignition switch can be turned to LOCK.
End Of Sie
SHIFT LOCK SYSTEM OUTLINE
E5U051430000N01
• To make operation smoother and to simplify internal construction, the shift lock system directly determines
movement of the slider block with the slider pin.
• The shift lock unit consists of the interlock cable, interlock cam, and lock unit.
End Of Sie
SHIFT-LOCK SYSTEM OPERATION
E5U051430000N02
The selector lever can be shifted from P position only when the following conditions are satisfied.
• The brake pedal is depressed.
1. When the brake pedal is not depressed, the slider
pin is pressed into the position shown below by
the brake pedal. Thus the slider block is inhibited
from moving in direction A via the cam. In this
condition, the interlock cable and interlock cam
are locked, and the guide pin on the shift lever
does not move out of the position. Thus the select
lever cannot be shifted to other than P position.
SPRING
CAM
CABLE END
SLIDER
OUTER CASING
INTERLOCK CABLE
IMPOSSIBLE TO
TURN KEY TO
LOCK POSITION
CHU0514S006
SPRING
CAM
CABLE END
SLIDER
OUTER CASING
INTERLOCK CABLE
POSSIBLE TO
TURN KEY TO
LOCK POSITION
CHU0514S007
SLIDER PIN
CAM
INTERLOCK CABLE
SLIDER BLOCK
A
SELECTOR
LEVER SIDE
BRAKE PEDAL
CHU0514S008
To Next Page
Loading...
