ON-BOARD DIAGNOSTIC
08–02–6
PID/data monitor table
PID name (definition) Unit/Condition Operation Condition (Reference) Terminal
BUCKLE_D
(Driver-side buckle switch
status)
Buckled/
Unbuckled
• Driver-side buckle switch on: Buckled
• Driver-side buckle switch off: Unbuckled
3A, 3D
BUCKLE_P
(Passenger-side buckle switch
status)
Buckled/
UNbuckled
• Passenger-side buckle switch on: Buckled
• Passenger-side buckle switch off: Unbuckled
3J, 3G
CCNT_RCM
(Number of continuous DTCs)
• DTCs detected: 1—255
• No DTCs detected: 0
CR2D_Comm
(Driver-side side air bag
sensor system communication
data error)
OK/
FAULT
• Sensor normal: OK
• Sensor communication malfunction: FAULT
2C, 2F
CR2D_Inter
(Driver-side side air bag
sensor system internal circuit
disabled)
OK/
FAULT
• Sensor normal: OK
• Sensor internal malfunction: FAULT
2C, 2F
CR2D_Mount
(Driver-side side air bag
sensor assembly incorrect)
OK/
FAULT
• Sensor normal: OK
• Sensor Install malfunction: FAULT
2C, 2F
CR2D_Short
(Driver-side side air bag
sensor system communication
error)
OK/
FAULT
• Sensor normal: OK
• Sensor open or short circuit: FAULT
2C, 2F
CR2P_Comm
(Passenger-side side air bag
sensor system communication
data error)
OK/
FAULT
• Sensor normal: OK
• Sensor communication malfunction: FAULT
2X, 2AA
CR2P_Inter
(Passenger-side side air bag
sensor system internal circuit
disabled)
OK/
FAULT
• Sensor normal: OK
• Sensor internal malfunction: FAULT
2X, 2AA
CR2P_Mount
(Passenger-side side air bag
sensor assembly incorrect)
OK/
FAULT
• Sensor normal: OK
• Sensor Install malfunction: FAULT
2X, 2AA
CR2P_Short
(Passenger-side side air bag
sensor system communication
error)
OK/
FAULT
• Sensor normal: OK
• Sensor open or short circuit: FAULT
2X, 2AA
DTC_CLR_ST*
(Seat weight sensor status)
Starting/
Normal End/
In Process/
OCS Fault
Fault information cleared at seat weight sensor 3B
IGN_V_2
(IG1 voltage)
V Ignition switch is at ON: B+
OCS_CAL_ST*
(Seat weight sensor
calibration status)
Starting/
Normal End/
Commanding/
NG (Voltage)/
NG (Weight)/
Timeout/
In Process/
OCS Fault
• Seat weight sensor calibration start-up: Starting
• Seat weight sensor calibration completed normally:
Normal End
• Seat weight sensor calibration command being sent:
Commanding
• Voltage malfunction during seat weight sensor calibration:
NG (Voltage)
• Weight error during seat weight sensor calibration: NG
(Weight)
• Seat weight sensor calibration time limit passed: Timeout
• Seat weight sensor calibration being processed: In
Process
• Seat weight sensor or Seat weight sensor control module
malfunction: OCS Fault
3B
OCS_PSG_ST*
(Seat weight sensor status)
Empty/
Child/
Adult/
OCS Fault
Occupant classification status determined by seat weight
sensor
3B
To Next Page
Loading...
