FUEL SYSTEM
01–14–6
QUICK RELEASE CONNECTOR (FUEL SYSTEM) FUNCTION [LF]
E5U011442692N01
• Quick release connectors that can be easily connected/disconnected have been adopted to improve
serviceability.
End Of Sie
QUICK RELEASE CONNECTOR (FUEL SYSTEM) CONSTRUCTION/OPERATION [LF]
E5U011442692N02
• There are two types of quick release connectors.
Quick release connector locations
Type A
• Used in the engine compartment.
• An SST is not used with this type.
• Mainly consists of a retainer and O-ring. The quick release connector is integrated with the fuel hose and
therefore cannot be disassembled.
• When the quick release connector is connected,
the fuel pipe projection is locked at the clamp lock
point. By pushing the clamp release tab to
expand the clamp, the lock point is released
allowing the fuel pipe to be disconnected.
• To connect the quick release connector properly,
push it into the fuel pipe until a locking click sound
is heard.
• New quick release connectors are fitted with a
checker tab that prevents improper fit. This
checker tab cannot normally be removed. When
the quick release connector is properly connected
to the fuel pipe, the lock is released and the
checker tab comes off. Due to this, it can be
verified that the quick release connector is
completely connected.
TYPE A
TYPE B
FUEL PUMP UNIT
FUEL TANK SIDE
ENGINE COMPARTMENT SIDE
E5U114ZW5011
QUICK RELEASE CONNECTOR
RELEASE TAB
LOCK POINT
C3U0114S091
FUEL PIPE
CHECKER TAB
C3U0114S092
To Next Page
Loading...
