Mazda 2006 RX-8 - Coupler Component Outline [Sj6 A-El]; Shift Control Outline [Sj6 A-El]; Active Adaptive Shift (AAS) Mode

AUTOMATIC TRANSMISSION [SJ6A-EL]
05–13–30
COUPLER COMPONENT OUTLINE [SJ6A-EL]
EHU051321101106
• The coupler component are installed on the transmission case as the grouped connectors of the TFT sensor
and solenoids.
.
End Of Sie
SHIFT CONTROL OUTLINE [SJ6A-EL]
EHU051318901106
• Based on the shift diagram, shift solenoids A, B, C, D, E, F, and G are controlled according to the vehicle speed
and the throttle opening angle, and the shift control of the transmission is performed.
• When certain conditions are met, the TCM selects a shift mode suitable to the driving conditions and
automatically switches to the mode to perform smooth shifting.
Active Adaptive Shift (AAS) Mode
• When certain conditions are met, AAS mode is automatically selected from normal mode. In AAS mode, the
shift point is set higher than the normal shift point so that high-engine speed, high-output conditions are
available.
• AAS mode is canceled when the vehicle speed remains constant (stable vehicle behavior).
Conditions for switching to active adaptive shift (AAS) mode
• The accelerator pedal is depressed fully to accelerate rapidly while driving in D range.
• Rapid acceleration or deceleration continues for a certain period of time while driving in D range.
LINE PRESSURE
CONTROL SOLENOID
SHIFT
SOLENOID E
SHIFT
SOLENOID F
SHIFT
SOLENOID D
SHIFT
SOLENOID G
SHIFT
SOLENOID A
SHIFT
SOLENOID B
SHIFT
SOLENOID C
TCC CONTROL
SOLENOID
TFT SENSOR
A
B
HJLN
D
F
GEC
IKMO
E5U513ZS5032
Terminal
No.
Signal
A TFT sensor (–)
B TFT sensor (+)
C Shift solenoid G (–)
D Shift solenoid G (+)
E Shift solenoid F (–)
F Shift solenoid F (+)
G TCC control solenoid (–)
H TCC control solenoid (+)
I Line pressure control solenoid (–)
J Line pressure control solenoid (+)
K Shift solenoid E
L Shift solenoid D
M Shift solenoid C
N Shift solenoid B
O Shift solenoid A
Terminal
No.
Signal