Mazda 2008 3 - Lighting and Wiper Controls; Turn Signal and Headlight Lever; Windshield Wiper System

21
AUTO
GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Turn signal/lighting
control lever
OFF = Lights off
= Tail, parking and
dashboard lights on: Rotate
knob (1) to first notch
= Tail, parking, dashboard
and headlights on: Rotate
knob (1) to second notch
AUTO* = With ignition switch
in ON position; headlights and
exterior lights automatically turn
ON/OFF depending on surrounding
darkness/lightness; rotate knob
(1) to third notch
High beams on/off: Push
forward/pull back to detent.
To flash high beams: Pull back
slightly and release.
= Fog lights* on: Rotate (2);
functions only with headlight
low beams on
Turn signals right/left: Move
lever up/down.
Tip: Headlights turn off and
parking lights remain on if
headlight switch is left on
and ignition switch is in lock
position or key is removed.
REAR
1
REAR
13
INT
REAR
12
INT
Wiper/washer control lever
Single wipe: Push lever up.
Washer: Pull back, also
operates wipers.
Intermittent wiper: One click down.
To change interval speed:
Rotate inner ring* (2).
Normal wiper speed: Two clicks down.
High-speed wiper: Three clicks down.
Auto*: One click down.
Rain sensor senses rain amount
on windshield, then controls
wiper automatically.
Rain sensor sensitivity is adjusted
from high sensitivity (+) to less
sensitivity (
- ) by rotating ring (3).
Getting
Started
Getting
Started
Rear window wiper/
washer (5-Door only)
To activate rear interval wiper:
Rotate knob (1) up to INT.
To activate rear normal speed
wiper: Rotate knob (1) up to ON.
To activate rear washer: Rotate
knob (1) to and release.
*Denotes optional equipment