Mazda 2009 CX-7 - Page 122

Black plate (122,1)
qOperating the Moonroof
Tilt Operation
The rear of the moonroof can be tilted
open to provide more ventilation.
To fully tilt automatically, momentarily
press the rear of the tilt switch.
To fully close automatically, momentarily
press the front of the tilt or slide switch.
To stop tilting partway, press any part of
the tilt or slide switch.
Close
Tilt up
Close
Slide Operation
To fully open automatically, momentarily
press the rear of the slide switch.
To fully close automatically, momentarily
press the front of the tilt or slide switch.
To stop sliding partway, press any part of
the tilt or slide switch.
Close
Close
Open
Power moonroof re-set procedure
If the battery had been disconnected
during vehicle maintenance or for other
reasons, the moonroof may not fully open
or close. The moonroof's jam-safe
function does not function while the
moonroof is re-setting. Carry out the
following procedure to resume operation:
1. Turn the ignition switch to the ON
position.
2. Press the rear of the tilt switch, to
partially tilt open the rear of the
moonroof.
NOTE
If the re-set procedure is performed while the
moonroof is in the slide position (partially
open) it closes before the rear tilts opens.
3. Repeat the procedu re in Step 2. The
rear of the moonroof tilts open to the
fully open position, then closes a little.
3-44
Knowing Your Mazda
Doors and Locks
CX-7_8Z60-EA-08D_Edition2 Page122
Friday, May 30 2008 5:27 PM
Form No.8Z60-EA-08D