Mazda 2010 CX-7 - A Word to Mazda Owners; Important Notes About This Manual

3 4
To Program the Driver’s Seat Position
1 Parkvehicle.
2 AdjustseattodesiredpositionusingtheSlide/TiltandReclineswitches.
3 WhileholdingtheSETbuttonin,pushoneofthethree(3)programming
buttonsuntilabeepisheard.Programmingisnowcomplete.Program
remainingtwobuttonsasdesired.
NOTE: Youcanalsoprogramoneseatpositionforeachadvancedkey/retractable
typekeyusedwiththevehicle.SeeOwner’sManualforprogramminginstructions.
To Move the Seat to a Programmed Position
 •  With driver’s door OPEN and ignition OFF,pushandreleaseone
oftheprogrammedbuttons(1,2,or3)whenenteringthevehicle.
OR
 •  With driver’s door CLOSED and ignition ON,pushandholdoneof
theprogrammedbuttons(1,2,or3).
NOTE:
MemoryseatfunctionsDONOToperatewhendriver’sdoorisOPENand
ignitionisON,whendriver’sdoorisCLOSEDandignitionisOFF,orwhenthevehicle
isinmotion.
ELECTRONICALLY OPERATED DRIVER SEAT CONTROLS
Returning second-row seats to upright position
1 Raiseseatbacksuntiltheylockintoposition(redindicatorisnot
  visiblewhenseatisinthelockedposition).
2 Pullonthetopoftheseatbacksfrominsidethevehicle
tomakesuretheyarelocked.
3 Checkthatallseatbeltsareroutedproperlyforpassengeruse.
Seatback Knob
Slide/Tilt Switch
Seatcanbemoved
backandforth,raised,
lowered,ortiltedwith
thiscontrol.
Recline Switch
Pushforwardorbackward
toadjustseatbackangle.
Memory Seat Switch
FOLDING SECOND-ROW SEATS
1 Unfastenthelapportionoftherearcenterseatbelt.
2 Supporttheseatbackwithyourhand.
3 Pushtherearseatbackknobdown(redindicatorisvisiblewhen
  seatisintheunlockedposition).
4 Bringtheseatbackforward.
Seats
211069_10b_Mazda_CX-7_SSG_063009.indd 4-5 6/30/09 3:52:30 PM