Mazda 2012 CX-7 - Page 320

Black plate (319,1)
After a device is registered, the system
automatically identifies the device. By
activating Bluetooth
®
Hands-Free again,
or by activating Bluetooth
®
Hands-Free
first after switching the ignition from OFF
to ACC, the system reads out a voice
guidance, “XXXXXX - - - (Ex. “Stan's
device”) (Device tag) is connected”.
NOTE
l
Device registration can also be done by
operating the audio unit or panel buttons
on the navigation unit.
l
(Without 7-inch navigation system)
Refer to Bluetooth® Audio Preparation
on page 6-63.
l
(With 7-inch navigation system)
Refer to the separate manual
“NAVIGATION SYSTEM Owner's
Manual”
l
Depending on the device, the registration
status may be lost after a certain period of
time. If this occurs, repeat the entire
process from Step 1.
qMaking a Call Using a Telephone
Number
NOTE
Practice this while parked until you are
confident you can do it while driving in a non-
taxing road situation. If you are not completely
comfortable, make all calls from a safe
parking position, and move out only when fully
under control and you can devote your eyes
and mind to driving.
(Without 7-inch navigation system)
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] “Dial”
3. Prompt: “Number, please”
4. Say: [Beep] “XXXXXXXXXXX
(Telephone number)”
5. Prompt: “XXXXXXXXXXX.
(Telephone number) After the beep,
continue to add numbers, or say Go-
Back to re-enter the last enter ed
numbers, or press the Pick-Up button
to execute dialing.”
6. (Dialing)
Press the pick-up button or say “Dial”,
then go to Step 7.
(Adding/input ting telephon e
number)
Say, “XXXX” (desired telephone
number), then go to Step 5.
(Telephone number correction)
Say, “Go Back”. The prompt replies,
“Go Back. The last entered numbe rs
have been removed. ” . Then go back to
Step 3.
7. Prompt: “Dialing”
(With 7-inch navigation system)
1. Press the pick-up button or talk button
with a long press.
NOTE
For vehicles with the 7-inch navigation system,
you can also press the talk button with a short
press and say: [Beep] “Telephone” or
“Phone”.
2. Say: [Beep] “Dial”
3. Prompt: “Number, please”
4. Say: [Beep] “XXXXXXXXXXX (Ex.
“555-1234”) (Telephone number)”
5. Prompt: “Dialing XXXXXXXXXXX
(Ex. “555-1234”) (Telephone number)
is this correct?”
6. Say: [Beep] “Yes” or “ No”.
Interior Comfort
Bluetooth® Hands-Free
6-81
CX-7_8CG4-EC-11J_Edition1 Page319
Monday, October 3 2011 11:14 AM
Form No.8CG4-EC-11J