Black plate (295,1)
l
A new CD may have rough edges on
its inner and outer perimeters. If a disc
with rough edges is used, proper
setting will not be possible and the CD
player will not play the CD. In
addition, the disc may not eject
resulting in a malfunction. Remove the
rough edges in advance by using a ball-
point pen or pencil as shown below. To
remove the rough edges, rub the side of
the pen or pencil against the inner and
outer perimeter of the CD.
l
When driving over uneven surfaces,
the sound may jump.
l
The CD player has been designed to
play CDs bearing the identification
logo as shown below. No other discs
can be played.
l
Use discs that have been legitimately
produced. If illegally-copied discs such
as pirated discs are used, the system
may not operate properly.
l
Be sure never to touch the signal
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
l
Do not stick paper or tape on the CD.
Avoid scratching the reverse side (the
side without a label). The disc may not
eject resulting in a malfunct ion.
l
Dust, finger smudges, and dirt can
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD should
become soiled, gentl y wipe it with a
soft cloth from the center of the CD to
the edge.
l
Do not use record sprays, antistatic
agents, or household spray cleaners.
Volatile chemicals such as benzine and
thinner can also damage the surface of
the CD and must not b e used. Anything
that can damage, warp, or fog plast ic
should never be used to clean CDs.
l
Insert discs one by one. If two discs are
inserted at the same time, the system
may not operate properly.
l
The CD player ejects the CD if the CD
is inserted upside down. Also dirty
and/or defective CDs may be ejected.
l
Do not insert cleaning discs in the CD
player.
Interior Comfort
Audio System
6-21
CX-9_8DU1-EA-14H_Edition1 Page295
Thursday, June 5 2014 4:18 PM
Form No.8DU1-EA-14H
To Next Page
Loading...
