Mazda 3 - Page 242

4 – 98
When Driving
i-ELOOP
i-ELOOP Indicator Light/Control
Status Display
T h e d r i v e r i s n o t i ¿ ed of the i-ELOOP
power generating status and the vehicle
conditions by the i-ELOOP indicator light
and the control status display.
i-ELOOP Indicator Light
Illuminated (vehicle without type C/type
D audio)
The light turns on during power
generation.
Flashing
If the engine is started after the vehicle has
not been driven for a long period of time,
the i-ELOOP indicator light may À ash.
Leave the engine idling and wait until the
indicator light turns off.
NOTE
 
The beep will sound if the vehicle is
driven while the i-ELOOP indicator
light is À ashing. In addition, if you
turn the steering wheel while the
light is À ashing, it will feel heavier
than normal, but this does not
indicate an abnormality. Stop the
vehicle in a safe location with the
engine running and do not attempt to
turn the steering wheel. The steering
operation will return to normal after
the i-ELOOP indicator light stops
À ashing.
 
(Vehicles with type C/type D audio)

A noti¿ cation is displayed in the
centre display and the i-ELOOP
indicator light À ashes at the same
time.

Refer to Warning Message Indicated
on Display on page 7-49 .
Control status display (vehicles with
type C/type D audio)
The i-ELOOP power generating status is
displayed in the centre display.
Refer to Control Status Display on page
4-100 .
/C\FCA(,'''A'FKVKQPKPFD/C\FCA(,'''A'FKVKQPKPFD 