Mazda 3 - Page 292

4 – 148
When Driving
i-ACTIVSENSE
NOTE
 
The Mazda Radar Cruise Control (MRCC) system operates when all of the following
conditions are met.
 
The vehicle speed is as follows:
 
(European models)

About 30 km/h (19 mph) to 200 km/h (124 mph)
 
(Except European models)
About 30 km/h (19 mph) to 145 km/h (90 mph)
 
The Mazda Radar Cruise Control (MRCC) system is turned on.
 
The parking brake is not applied.
 
The Smart Brake Support (SBS) is not malfunctioning.
 
The Dynamic Stability Control (DSC) is operating normally.
 
All doors are closed.
 
The driver's seat belt is fastened.

(Manual transaxle)
 
The shift lever is in a position other than reverse (R) or neutral (N).
 
The clutch pedal is not depressed.

(Automatic transaxle)
 
The selector lever is in the drive (D) position or manual (M) position (manual mode).
 
In the following cases, the warnings may not activate even if your vehicle starts
closing in on the vehicle ahead.
 
You are driving at the same speed as the vehicle ahead.
 
Directly after the Mazda Radar Cruise Control (MRCC) system has been set.
 
When the accelerator pedal is depressed or directly after the accelerator pedal is released.
 
Another vehicle cuts into the driving lane.
 
The following are not detected as physical objects.
 
Vehicles approaching in the opposite direction
 
Pedestrians
 
Stationary objects (stopped vehicles, obstructions)
 
If a vehicle ahead is travelling at an extremely low speed, the system may not detect it correctly.
 
During headway control travel, do not set the system on two-wheeled vehicles such as
motorcycles and bicycles.
 
Do not use the Mazda Radar Cruise Control (MRCC) system under conditions in
which the close proximity warnings are frequently activated.
 
During headway control travel, the system accelerates and decelerates your vehicle in conjunction
with the speed of the vehicle ahead. However, if it is necessary to accelerate for a lane change
or if the vehicle ahead brakes suddenly causing you to close in on the vehicle rapidly, accelerate
using the accelerator pedal or decelerate using the brake pedal depending on the conditions.
/C\FCA(,'''A'FKVKQPKPFD/C\FCA(,'''A'FKVKQPKPFD 