Black plate (21,1)
4. Push the rear seatback knob down.
To return the seatbacks to the upright
position
1. Position the outboard seat belts to the
side.
2. Lift the seatbacks upright.
3. Make sure the seat belts are fully
pulled out from under the seatbacks.
4. Pull on the top of the seatbacks from
inside the vehicle to make sure they are
locked.
5. Fasten the rear-center lap/shoulder belt
and check that a ll seat belts are routed
properly for passenger use (page 2-16).
WARNING
Seat Belts Caught Under Seatbacks:
A seat belt caught under a seatback
after the seatback is returned to its
upright position is dangerous. In a
collision or sudden stop, the seat belt
cannot provide adequate protection.
Always make sure the seat belts are
fully pulle d out from under the
seatbacks.
Returning Rear Seatbacks to the
Upright Position:
A rear seatback not fully returned and
locked in the upright position is
dangerous. Sudden stops or
maneuvering could cause a seatback
to flip forward suddenly resulting in
injury. If the red indicator is visible on
the back of the rear seatback knob, the
seatback is not locked in the upright
position. When returning the seatback
to the upright position, make sure
there is no red indication.
Locked position
Unlocked position
Red indicator
Essential Safety Equipment
Seats
2-7
Mazda3_8T97-EC-04J_Edition1 Page21
Saturday, September 25 2004 2:7 PM
Form No.8T97-EC-04J
Ofrecido por www.electromanuales.com
To Next Page
Loading...
