Essential
Safety Equipment
2-14
J Fr
ont Center Seat Belt
(No Retractor)
The lap belt does not adjust automati-
cally.
To fasten:
1. Grasp the tongue plate and pull it to
the desired length. To lengthen the
belt, hold the tongue at a right angle
to the webbing and pull; to shorten,
pull the loose end of the webbing.
2. Insert the tongue into the correct
buckle (the buckle closest to the
direction
the tongue is coming from).
3. Pull slightly to ensure a proper con-
nection.
4. Adjust
belt so that it fits snugly and as
low as possible around the hips.
To unfasten:
Depress
t
h
e b
utto
n o
n
t
h
e b
uckle
. S
horten
and fasten the belt when not in use.
J
Rear
Lap Belts W
ith
Retractors
The lap belt will adjust automatically.
To fasten:
Grasp
the
tongue, and with a continuous
motion, pull out enough webbing to
buckle the tongue into the correct
buckle. If you did not pull out enough
webbing to reach the buckle, allow the
tongue to retract fully before trying to
pull
it out again. The lap belts should
fit
snugly
and as low as
possible around the
hips, not around the waist.
If
you need to lengthen the belt,
unfasten
it and repeat the procedure above.
To unfasten:
Push
in the release button prior to open
-
ing the rear door.
NOTE
On 4-door cab plus vehicles, do not
open
the rear door when the rear seat
belt is still buckled.
To Next Page
Loading...
