NO.7 TCS/DSC INDICATOR LIGHT FLASHES (WHEN NEITHER THE TCS NOR THE DSC ARE OPERATING) [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0403b2896200.html[1/7/13 9:32:02 AM]
< Previous Next >
2013 - CX-5 - Brakes
NO.7 TCS/DSC INDICATOR LIGHT FLASHES (WHEN NEITHER THE TCS NOR THE DSC ARE
OPERATING) [DYNAMIC STABILITY CONTROL (DSC)]
7 TCS/DSC indicator light flashes (when neither the TCS nor the DSC are operating)
POSSIBLE
CAUSE
Non-completion of DSC related parts sensor initialization. (If the initialization is
not carried out after replacing the DSC HU/CM and/or SAS control module, a
TCS/DSC indicator light will flash. In this case, the DSC is not detected.)
Diagnostic procedure
STEP INSPECTION ACTION
1
INSPECT CONNECTION OF DSC HU/CM AND SAS
CONTROL MODULE CONNECTORS
Inspect for connection of DSC HU/CM and
SAS control module (yaw rate sensor, low-
G sensor) connectors.
Are DSC HU/CM and SAS control module
connectors connected securely?
Yes Perform the initialization procedure.
(See
DSC RELATED PARTS SENSOR
INITIALIZATION PROCEDURE
.)
No Perform the initialization procedure
after connect the suspected connector
securely.
(See
DSC RELATED PARTS SENSOR
INITIALIZATION PROCEDURE
.)
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.
To Next Page
Loading...
