12
Rear combination light removal
1. Insert a tape-wrapped flathead screwdriver into the service hole
in the position shown in the figure.
2. Move the flathead screwdriver in the direction of the arrow (1)
shown in the figure, pull out the service hole cover, and detach
the service hole cover tab and trunk side trim.
3. Pull out the service hole cover in the direction of the arrow (2)
shown in the figure and pull out the service hole cover hook from
the trunk side trim.
4. Remove the service hole cover.
x Fogging or condensation on the inside of the rear
combination lights may occur due to a natural phenomenon
occurring as a result of a temperature difference between
the interior and exterior of the combination lights. However,
it has no effect on the light performance because the
temperature inside the rear combination lights rises after
illuminating the brake/taillight bulbs or a period of time has
elapsed.
Service hole
SERVICE HOLE COVER
Front
Back
Tab A
Tab B
Vehicle
Front
Tab A
Tab B
(1)
Flathead screwdrive
To Next Page
Loading...
