Mazda CX-5 - Sensor Installation Position Marking (Rear Bumper)

30 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

6

ع

Sensor installation position marking (rear bumper)

1. Open the liftgate.

2. Set the selector lever to P range.

3. Disconnect the negative battery cable. (Refer to 8 page.)

4. Punch a drill guide mark in the center of the hole drilling position (4 locations) using a punch.

4. BEFORE INSTALLATION

x Mark the drilling position for the rear bumper before removing the vehicle parts.

CAUTION

Table of Contents