Mazda CX-5 - Optional ON-OFF Switch Installation Position Marking (Trunk Side Trim (LH))

7
ع
Optional ON-OFF switch installation position marking (trunk side trim (LH))
1. Open the liftgate.
2. Set the selector lever to P range.
3. Disconnect the negative battery cable. (Refer to 8 page.)
4. Punch a drill guide mark in the center of the hole drilling position (2 locations) using a punch.
x Mark the drilling position for the trunk side trim (LH) before removing the vehicle parts.
CAUTION
53mm
22mm
10mm
Drill guide mark
Trunk side trim (LH)
Cargo light