8
Negative battery cable disconnection
1. Set the selector lever to P range.
(AT vehicles only)
2. Disconnect the negative battery cable and wrap tape around it
to insulate.
Tightening torque : 4.0-6.0 N
m
Cover assy-tonneau removal
(if equipped)
1. Remove the holder on the left end of the cover assy-tonneau
into the mounting hole of the trunk side trim.
2. Retract the holder on the right end of the cover assy-tonneau
and remove it into the mounting hole.
5
VEHICLE PART REMOVAL
x Be careful not to damage or lose any parts removed from the vehicle since they will be reused.
CAUTION
Mounting hole
Holder
Cover assy-tonneau
Trunk
side
trim
Cover assy-tonneau
Trunk
side
trim
Holder
Mounting hole
Retract
x When the negative battery cable is connected during
operation, it may cause electric shock or other personal
injuries. Disconnect the negative battery cable before
removal/installation.
WARNING
x When removing/installing the parts, park the vehicle on
level ground and apply the side brake securely. Be sure to
turn the ignition switch off, otherwise the vehicle can move,
causing personal injury or vehicle damage.
WARNING
Ne
To Next Page
Loading...
