Mazda CX-50 2024 - Page 251


In the following cases, the
i-ACTIVSENSE warning indication/
warning light turns on and operation
of the system is stopped. If the
i-ACTIVSENSE warning indication/
warning light remains illuminated,
have the vehicle inspected at an
Authorized Mazda Dealer as soon as
possible.

Some problem with the system
including the BSM warning
indicator lights is detected.

A large deviation in the installation
position of a rear side radar sensor
on the vehicle has occurred.

There is a large accumulation of
snow or ice on the rear bumper
near a rear side radar sensor.
Remove any snow, ice or mud on
the rear bumper.

Driving on snow-covered roads for
long periods.

The temperature near the rear side
radar sensor becomes extremely
hot due to driving for long periods
on slopes during the summer.

The battery voltage has decreased.

Under the following conditions, the
rear side radar sensor cannot detect
target objects or it may be
dicult
to
detect them.

The rear bumper around the rear
side radar sensor is deformed.

Radio wave interference from a
radar sensor equipped on a nearby
vehicle.

The approaching vehicle is any of
the following shapes.
a) The size of the vehicle body is
extremely small.
b) The vehicle height is extremely
low or high.
c) A special type of vehicle with a
complex shape.

A vehicle is in the detection area at
the rear in an adjacent driving lane
but it does not approach. The BSM
determines the condition based on
radar detection data.

A vehicle is traveling alongside
your vehicle at nearly the same
speed for an extended period of
time.

Vehicles approaching in the
opposite direction.

A vehicle in an adjacent driving
lane is attempting to pass your
vehicle.

A vehicle is in an adjacent lane on
a road with extremely wide driving
lanes. The detection area of the
rear side radar sensor is set at the
road width of expressways.

In the following case, the flashing of
the BSM warning indicator light, and
the activation of the warning sound
and the warning screen indicator
display may not occur or they may be
delayed.

A vehicle makes a lane change
from a driving lane two lanes over
to an adjacent lane.

Driving on steep slopes.

Crossing the summit of a hill or
mountain pass.

When there is a dierence in the
height between your driving lane
and the adjacent lane.

Directly after the BSM system
becomes operable by changing the
setting.

If the road width is extremely
narrow, vehicles two lanes over may
be detected. The detection area of
the rear side radar sensor is set
according to the road width of
expressways.
When Driving
i-ACTIVSENSE
4-100
CX50_8MG7-EA23G_Edition1_new 2023-3-13 9:43:28