Mazda CX-7 2007 - Wire Harness Connections - Steering Column; Ignition Switch Connector; Parking Light Connection

10
4280246 Rev. B 11/10
WIRE HARNESS CONNECTIONS - STEERING COLUMN
9
!
FIGURE DD
IGNITION SWITCH CONNECTOR
1. Route the remote start ignition harness with 6-pin male and fe-
male ignition connectors over the factory harness, along the
left side of the steering column. Do not secure harness at this
time.
2. Locate the 6-pin WHITE ignition connector, on the left side of
the steering column.
3. Release the red secondary lock and disconnect the 6-pin WHITE
ignition connector by pulling outward. ( CAUTION: DO NOT
PULL ON WIRES TO DISCONNECT CONNECTOR.)
4. Plug the 6-pin female remote start harness connector into the
factory ignition switch and engage the red secondary lock.
(FIGURE DD)
5. Plug the 6-pin male remote start harness connector into the 6-
pin female factory ignition connector and engage the red sec-
ondary lock. (FIGURE DD)
PARKING LIGHT CONNECTION
1. Locate the 17-pin multifunction switch connector on the left side
of the steering column (plugged into the turn signal assembly).
(FIGURE EE)
2. Using a razor knife carefully cut back 1”-2” of the electrical tape
to expose the wiring. ( CAUTION: BE EXTREMELY CARE-
FUL NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE EE
& FF for proper connector and pin location.
!
FIGURE EE
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
FIGURE FF
VEHICLE’S PARKING LIGHT WIRE REMOTE START HARNESS WIRE
2010 MODELS - BLACK/BLUE BLACK/RED
2007-2009 MODELS - BLACK/RED BLACK/RED
VIEW FROM HARNESS SIDE
B/Y
B/R
B/L
B/R B/O
&B/R
B/L
B/G
B/R
B
JH DL
QO
2010 MODELS
B/Y
B/R
B/L
B/R B/O
&B/R
B/R
B/G
B/R
B
JH DL
QO
VIEW FROM HARNESS SIDE
2007-2009 MODELS