4
4280246 Rev. B 11/10
REMOTE START CONTROL MODULE PREPARATION
1. Insert the supplied fuses into the remote start control module as shown below. (FIGURE F)
The fuses fit tightly, so use the flat tip of a fiber stick to push them in place, if necessary.
2. Install DNA card into the remote start control module as shown below. (FIGURE G)
CAUTION: Use care to assure that both rows of the multi-pin connector are aligned and
seated properly.
3. Plug the supplied wire harness 10-way and 24-way connectors into the remote start control mod-
ule. (FIGURE H) Make sure the connectors are seated completely. NOTE: The connectors will
only plug into the remote start control module one way.
4. Plug the supplied immobilizer interface 4-way connector into the remote start control module.
(FIGURE H)
NOTE: TAPE OFF THE WHITE WIRE (IF EQUIPPED) COMING FROM THE 4-WAY
CONNECTOR (THIS WIRE IS NOT USED ON THIS SYSTEM).
2
FIGURE F
FIGURE G
REMOTE ENGINE START MODULE AND IMMOBILIZER INTERFACE MOUNTING
3
REMOTE ENGINE START MODULE MOUNTING
1. Locate the two large wire harnesses high up under the dash-
board running near the vehicle dashwall.
2. Using (3) supplied long wire ties, secure the remote start con-
trol module to the wire harnesses. (FIGURE I)
IMMOBILIZER INTERFACE MODULE MOUNTING
1. Locate the large wire harness routed toward the diagnostic
conntector. (FIGURE J)
2. Using (1) supplied long wire tie, secure the immobilizer inter-
face to the wire harness. (FIGURE J)
Tie Wraps
Tie Wraps
5
15
15
15
15
15
15
5
15
15
15
15
15
15
-+
-+
15
HVAC 1
HVAC 2
MAIN B+
IGNITION
DOME LIGHT
PK LIGHTS
DOOR LOCKS
15
TRUNK RELEASE
FIGURE I
FIGURE J
FIGURE H
!
To Next Page
Loading...
