8
4280246 Rev. B 11/10
GROUND CONNECTION
1. Locate the 10 mm factory bolt located at the bottom left of the metal
brace supporting the diagnostic connector. (FIGURE V)
2. Using a 10 mm ratchet remove the 10 mm lug bolt.
3. Re-secure the factory ground ringlet and remote start harness
BLACK/ORANGE ground wire with ringlet and tighten with a 10 mm
ratchet.
NOTE: USING A 3/8” DRIVE TORQUE WRENCH MAKE SURE
THAT THE 10 mm GROUND LUG BOLT IS SECURELY
TIGHTENED TO 78-121 INCH/POUNDS.
7
HOOD SAFETY SWITCH WIRE CONNECTIONS
1. Locate the BLACK/ORANGE and GRAY/RED wires from the remote start system harness.
2. Using the (2) supplied IDC wire taps (in hood safety switch parts bag), connect the wires listed
below together and crimp the IDC wire taps in place using pliers. Ensure that a complete and
secure connection is made.
6
HOOD SAFETY SWITCH WIRE REMOTE START HARNESS WIRE
Dk. GRAY GRAY/RED
Dk. GRAY BLACK/ORANGE
NOTE: Switch is not polarity sensitive.
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
FIGURE V
To Next Page
Loading...
