1031989 Rev. A 5/07
3
REMOVE DRIVER’S SCUFF PLATE AND LEFT KICK PANEL
1. USING A FIBER STICK, REMOVE THE DRIVER’S SIDE SCUFF PLATE. THE SCUFF
PLATE IS HELD BY (3) CLIPS. (FIGURE B)
2. REMOVE THE DRIVER’S SIDE KICK PANEL BY REMOVING THE PLASTIC NUT.
(FIGURE C) PARTIALLY PEEL BACK THE RUBBER WEATHERSTRIP AWAY FROM THE
KICK PANEL. INSERT A FIBER STICK BETWEEN THE BODY AND KICK PANEL TO
DISENGAGE THE RETAINING CLIP. GENTLY PULL THE KICK PANEL TOWARD THE
CENTER OF THE VEHICLE TO REMOVE.
FIGURE B
Plastic Nut
FIGURE C
1
FIGURE A
DISCONNECT THE BATTERY
1. DISCONNECT AND ISOLATE THE NEGATIVE BATTERY CABLE.
(FIGURE A)
10 mm
Socket
2
CAUTION: DO NOT OVERTIGHTEN COVERED NUT.
1. LOCATE THE PREVIOUSLY REMOVED DRIVER’S KICK PANEL.
2. CENTER PUNCH THE DRIVER’S KICK PANEL, EXACTLY 12 mm DOWN FROM
THE TOP AND 95 mm LEFT OF THE FAR EDGE. (FIGURE D)
3. CAREFULLY DRILL A 9/32” DIAMETER HOLE AT THE CENTER PUNCHED
LOCATION.
4. DISCONNECT THE EMERGENCY OVERRIDE BUTTON FROM THE SECURITY
HARNESS BY UNPLUGGING THE TWO 2-PIN WHITE CONNECTORS.
5. REMOVE THE COVERED NUT AND LOCK WASHER FROM THE EMERGENCY
OVERRIDE BUTTON AND INSERT THE BUTTON THROUGH THE DRILLED HOLE
FROM THE BACK SIDE OF THE DRIVER’S SIDE KICK PANEL.
NOTE: DISCARD THE LOCK WASHER, IT IS NOT USED ON THIS MODEL.
6. REPLACE THE LOCK COVERED NUT AND CAREFULLY TIGHTEN BY HAND.
3
MOUNT THE EMERGENCY OVERRIDE BUTTON
FIGURE D
!
To Next Page
Loading...
