1031989 Rev. A 5/07
4
REMOVE STEERING COLUMN COVERS
1. REMOVE THE (3) PHILLIPS HEAD SCREWS FROM THE LOWER STEERING COLUMN
COVER. (FIGURE E)
2. INSERT A FIBER STICK BETWEEN THE COMBINATION SWITCH AND THE LOWER
COVER. GENTLY ROTATE THE FIBER STICK UNTIL THE TOP AND BOTTOM COVERS
SEPERATE. (FIGURE E)
3. IF EQUIPPED, GENTLY UNCLIP THE IGNITION KEY LIGHT AND REMOVE BOTH
TOP AND BOTTOM COVERS AND SET ASIDE WHERE THEY CANNOT BE
DAMAGED.
4
FIGURE E
!
CAUTION: BE CAREFUL NOT TO DAMAGE PLASTIC COVERS.
6
REMOVE LOWER DASH PANEL
FIGURE G
1. USING A SMALL FLAT TIP SCREWDRIVER, REMOVE (2) PLASTIC
FASTNERS.
2. REMOVE THE BLACK LOWER DASH PANEL BY DISENGAGING THE
SINGLE CLIP LOCATED AT THE FRONT, CENTER OF THE PANEL.
(FIGURE G)
1. LOCATE THE PREVIOUSLY REMOVED UPPER STEERING COLUMN COVER. (FIGURE F)
2. CENTER PUNCH THE AREA NEAR THE COMBINATION SWITCH OF THE UPPER STEERING
COLUMN COVER 15 mm FROM INSIDE EDGE OF THE COMBINATION SWITCH OPENING
AND 15 mm FROM THE BOTTOM EDGE OF THE UPPER STEERING COLUMN COVER.
(FIGURE F)
3. CAREFULLY DRILL A 9/32” DIAMETER HOLE IN THE UPPER STEERING COLUMN COVER
AT THE CENTER PUNCHED LOCATION.
CAUTION: BE SURE NOT TO DRILL THE HOLE OVERSIZED.
4. PASS THE LED CONNECTOR AND WIRES THROUGH THE DRILLED HOLE FROM THE
FRONT SIDE OF UPPER STEERING COLUMN COVER. PRESS THE LED INTO THE HOLE
FIRMLY UNTIL FULLY SEATED.
5. POSITION UPPER STEERING COLUMN COVER IN FACTORY MOUNTING LOCATION.
DO NOT REINSTALL LOWER STEERING COLUMN COVER AT THIS TIME.
Lower Steering Column Cover
5
MOUNT THE DASH LED STATUS INDICATOR
15 mm
FIGURE F
15 mm
Upper Steering Column Cover
!
To Next Page
Loading...
