1031989 Rev. A 5/07
5
MOUNT THE CONTROL MODULE
7
FIGURE H
Body Control
Module
Wire Ties x 3
1. LOCATE THE 24-PIN CONNECTOR ON THE SECURITY SYSTEM HARNESS
AND ATTACH IT TO THE MATING 24-PIN CONNECTOR ON THE SECURITY
SYSTEM MODULE.
2. LOCATE THE 5-PIN CONNECTOR ON THE SHOCK SENSOR HARNESS
AND ATTACH IT TO THE MATING 5-PIN CONNECTOR ON THE SECURITY
SYSTEM MODULE.
NOTE: BE SURE TO ENGAGE THE 5-PIN CONNECTOR FROM THE SHOCK
SENSOR HARNESS TO THE SECURITY MODULE, NOT THE 4-PIN
CONNECTOR.
3. POSITION THE SECURITY MODULE ABOVE THE MAIN HARNESS RUNNING
ABOVE THE BODY CONTROL MODULE, IN THE LEFT KICK PANEL AREA.
(FIGURE H)
4. USING (3) OF THE SUPPLIED WIRE TIES, SECURE THE SECURITY
MODULE TO THE MAIN HARNESS USING THE EYELETS ON EACH SIDE
OF THE SECURITY MODULE.
5. BE SURE WIRE TIES ARE TIGHTENED COMPLETELY, THEN TRIM OFF
EXCESS.
1. LOCATE THE 10 MM FACTORY BOLT, MOUNTED HIGH UP UNDER
THE DASH, NEAR THE VEHICLE DASHWALL, SUPPORTING THE
FACTORY “UNIT - LIGHT AUTO OFF” MODULE. (FIGURE J)
2. USING A 10 MM SOCKET AND RATCHET, REMOVE THE 10 MM BOLT.
3. USING THE 10 MM BOLT JUST REMOVED, SECURE THE REMOTE START
HARNESS BLACK GROUND WIRE WITH RINGLET AND TIGHTEN
WITH A 10 MM SOCKET AND RATCHET.
NOTE: USING A 1/4” DRIVE TORQUE WRENCH, MAKE SURE THAT
THE 10 MM GROUND BOLT IS SECURELY TIGHTENED TO
78-121 INCH/POUNDS.
Unit-Light Auto Off
Module
Steering
Column
10 mm
Factory Bolt
9
FIGURE J
1. POSITION THE SHOCK SENSOR MODULE ON THE VEHICLE HARNESS
LOCATED TO THE LEFT OF THE STEERING COLUMN. (FIGURE I)
2. ATTACH A SUPPLIED, SHORT WIRE TIE THROUGH THE TOP MOUNTING
HOLE IN THE SHOCK SENSOR MODULE AND AROUND THE MAIN
HARNESS.
3. REPEAT STEP 2 FOR THE BOTTOM MOUNTING HOLE IN THE SHOCK
SENSOR MODULE.
4. BE SURE BOTH WIRE TIES ARE TIGHTENED COMPLETELY, THEN TRIM
OFF EXCESS.
5. LOCATE THE 4-PIN CONNECTOR ON THE SHOCK SENSOR HARNESS
AND ATTACH IT TO THE MATING 4-PIN CONNECTOR ON THE SHOCK
SENSOR MODULE.
8
Vehicle Harness
Steering
Column
MOUNT THE SHOCK SENSOR MODULE
FIGURE I
Shock Sensor
Harness
GROUND CONNECTION
To Next Page
Loading...
