1031989 Rev. A 5/07
6
10
IGNITION SWITCH CONNECTIONS
1. ROUTE THE SECURITY HARNESS WITH 6-PIN MALE AND FEMALE
IGNITION CONNECTORS WITH RED SECONDARY LOCK ALONG THE
LEFT SIDE OF THE STEERING COLUMN.
2. LOCATE THE 6-PIN WHITE IGNITION CONNECTOR, ON THE LEFT SIDE
OF THE STEERING COLUMN.
3. RELEASE THE RED SECONDARY LOCK AND DISCONNECT THE 6-PIN
WHITE IGNITION CONNECTOR BY PULLING OUTWARD. ( CAUTION:
DO NOT PULL ON WIRES TO DISCONNECT CONNECTOR.)
4. PLUG THE SECURITY HARNESS 6-PIN FEMALE CONNECTOR INTO
THE FACTORY IGNITION SWITCH AND ENGAGE THE RED SECONDARY
LOCK. (FIGURE K)
5. CONNECT THE SECURITY HARNESS 6-PIN MALE CONNECTOR INTO
THE FACTORY IGNITION SWITCH HARNESS CONNECTOR AND
ENGAGE THE RED SECONDARY LOCK. (FIGURE K)
FIGURE K
6 Pin Female
6 Pin Male
LED
HARNESS
SECURITY
HARNESS
CONNECT THE LED STATUS INDICATOR
1. LOCATE THE 2-PIN BLACK CONNECTOR ON THE SECURITY HARNESS.
2. ROUTE THE 2-PIN BLACK CONNECTOR AND WIRE HARNESS NEXT TO
THE SECURITY HARNESS ALONG THE LEFT SIDE OF THE STEERING
COLUMN AND SECURE WITH SUPPLIED WIRE TIES.
3. LOCATE THE 2-PIN BLACK CONNECTOR FROM THE LED HARNESS, WHICH
WAS PREVIOUSLY MOUNTED IN THE UPPER STEERING COLUMN COVER,
AND PLUG IT INTO THE 2-PIN BLACK CONNECTOR FROM THE SECURITY
HARNESS. (FIGURE L)
11
FIGURE L
PARKING LIGHT CONNECTION
1. LOCATE THE 17-PIN WHITE CONNECTOR PLUGGED INTO THE
MULTIFUNCTION SWITCH ON THE LEFT SIDE OF THE STEERING
COLUMN. (FIGURE M)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE
ELECTRICAL TAPE TO EXPOSE THE WIRING. ( CAUTION: BE
EXTREMELY CAREFUL NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW
AND CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A
COMPLETE AND SECURE CONNECTION IS MADE. REFER TO
FIGURE M & N FOR PROPER CONNECTOR AND PIN LOCATION.
VEHICLE’S PARKING LIGHT WIRE SECURITY HARNESS WIRE
BROWN BROWN/WHITE
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
FIGURE M
FIGURE N
VIEW FROM HARNESS SIDE
17-PIN
Connector #0918-102
Connector #C-01
12
!
!
To Next Page
Loading...
