1031989 Rev. A 5/07
7
13
BODY CONTROL MODULE CONNECTIONS
1. LOCATE THE 30-PIN, 6-PIN, 16-PIN AND THE 24-PIN CONNECTORS AT
THE BODY CONTROL MODULE LOCATED IN THE DRIVER’S KICK PANEL.
(FIGURE O)
FIGURE O
HORN CONNECTION
1. LOCATE THE 30-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER’S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & P FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE’S HORN WIRE SECURITY HARNESS WIRE
GREEN/RED GREEN/RED
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
14
FIGURE P
VIEW FROM HARNESS SIDE
DOOR TRIGGER CONNECTION
1. LOCATE THE 6-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER’S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & Q FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE’S DOOR TRIGGER WIRE SECURITY HARNESS WIRE
YELLOW/RED YELLOW/RED
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
15
FIGURE Q
!
VIEW FROM HARNESS SIDE
Connector #0940-01C
Connector #0940-01D
30-PIN Connector
#0940-01C
6-PIN Connector
#0940-01D
16-PIN Connector
#0940-01E
24-PIN Connector
#0940-01F
!
To Next Page
Loading...
