Mazda CX-9 2007 - Dynamic stability control (DSC);Roll stability control (RSC)

1031989 Rev. A 5/07
8
DISARM CONNECTION
1. LOCATE THE 16-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER’S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & S FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE’S DISARM WIRE SECURITY HARNESS WIRE
RED/YELLOW RED/YELLOW
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
17
FIGURE S
VIEW FROM HARNESS SIDE
LIFTGATE TRIGGER CONNECTION
1. LOCATE THE 24-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER’S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & T FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE’S LIFTGATE TRIGGER WIRE SECURITY HARNESS WIRE
LT. GREEN/RED LT. GREEN/ORANGE
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
18
VIEW FROM HARNESS SIDE
FIGURE T
ARM CONNECTION
1. LOCATE THE 16-PIN CONNECTOR AT THE BODY CONTROL MODULE IN THE
DRIVER’S KICK PANEL. (FIGURE O)
2. USING A RAZOR KNIFE, CAREFULLY CUT BACK 1”-2” OF THE ELECTRICAL
TAPE TO EXPOSE THE WIRING. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. USING (1) SUPPLIED WIRE TAP, CONNECT THE WIRE LISTED BELOW AND
CRIMP THE WIRE TAP IN PLACE USING PLIERS. ENSURE THAT A COMPLETE
AND SECURE CONNECTION IS MADE. REFER TO FIGURE O & R FOR PROPER
CONNECTOR AND PIN LOCATION.
VEHICLE’S ARM WIRE SECURITY HARNESS WIRE
RED RED
NOTE: REFER TO PAGE 2 FOR WIRE TAP PROCEDURE AND WIRE COLOR CODE INFORMATION.
16
VIEW FROM HARNESS SIDE
FIGURE R
Connector #0940-01E
Connector #0940-01E
Connector #0940-01F
!
!
!