1031989 Rev. A 5/07
9
SYSTEM POWER-UP
1. VERIFY THAT ALL CONNECTIONS ARE SECURE AS PER INSTALLATION INSTRUCTIONS.
NOTE: BE SURE THE ROOM FUSE IS INSTALLED IN THE FUSE PANEL.
2. RECONNECT THE NEGATIVE BATTERY TERMINAL.
3. IF THE HORN IS BEEPING AND THE PARKING LIGHTS FLASHING, TURN THE IGNITION TO THE ON POSITION AND PRESS THE EMERGENCY
OVERRIDE BUTTON LOCATED ON THE DRIVER’S KICK PANEL TO DISARM THE SYSTEM.
4. ENSURE THE IGNITION IS IN THE OFF POSITION BEFORE PROCEDING TO THE FUNCTION TEST.
20
CONNECT THE EMERGENCY OVERRIDE BUTTON AND REPLACE DRIVER’S KICK PANEL
1. LOCATE THE 2-PIN WHITE CONNECTOR ON THE SECURITY HARNESS.
2. LOCATE THE 2-PIN WHITE CONNECTOR FROM THE EMERGENCY OVERRIDE
BUTTON, WHICH WAS PREVIOUSLY MOUNTED IN THE DRIVER’S KICK
PANEL, AND PLUG IT INTO THE 2-PIN WHITE CONNECTOR FROM THE
SECURITY HARNESS. (FIGURE U)
3. RE-INSTALL THE DRIVER’S KICK PANEL BY ENGAGING THE RETAINING
CLIP ON THE PANEL. RE-INSTALL THE PLASTIC RETAINER AND REPLACE
THE WEATHERSTRIP. (FIGURE V)
19
FIGURE U
BUTTON
HARNESS
SECURITY
HARNESS
Plastic
Nut
FIGURE V
To Next Page
Loading...
