AIR BAG SYSTEM
08-10–2
AIR BAG SYSTEM OUTLINE
id081000100100
• The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag
system will not have the designed effect if the seat belts are not worn properly.
• The air bag system is composed of the following parts:
End Of Sie
Item Outline
SAS control module
• Two-step deployment control has been added to the front air
bag system (driver and passenger side) deployment control.
• A rollover control has been adopted which operates (deploys)
the curtain air bag module and pre-tensioner seat belts during
a vehicle rollover.
• Recognizes actually equipped air bag module or pre-
tensioner seat belt based on module configuration.
Crash zone sensor • Detects degree of impact, converts to an electrical signal, and
sends the signal to the SAS control module. For operation,
refer to SAS control module, Air bag module and pre-
tensioner seat belt deployment operation. (See 08-10-6 SAS
CONTROL MODULE CONSTRUCTION/OPERATION)
Side air bag sensor
Driver-side air bag module • Dual inflators, inflator 1 and inflator 2, have been adopted in
accordance with the front air bag system two-step
deployment control.
Passenger-side air bag module
Side air bag module
• Chest-protection type side air bag module is used in
accordance with the adoption of the curtain air bag module.
Curtain air bag module • Adopted to improve safety in lateral collisions.
Pre-tensioner seat belt • Piston-type pre-tensioner seat belt has been adopted.
Seat track position sensor
• Detects the seat track position of the driver’s seat, and sends
a corresponding signal to the SAS control module.
PAD indicator
• PAD indicator has been adopted to inform driver and
passenger of the deployment standby status of the
passenger-side air bag module, passenger-side side air bag
module, and passenger-side pre-tensioner seat belt.
Air bag system warning light • LED has been adopted.
Seat weight sensor
• Measures the compression weight of the load applied to the
passenger-side seat by the distortion amount using two seat
weight sensor and sends an electrical signal corresponding to
the distortion amount to the seat weight sensor control
module.
Seat weight sensor control module
• Based on the electrical signal sent from the seat weight
sensor corresponding to the distortion amount, calculates the
total seated weight to determine the passenger, and sends
the determination result to the SAS control module.
3423-1U-06H(08-10).fm 2 ページ ２００６年１１月２２日 水曜日 午後２時５４分
To Next Page
Loading...
