Make sure there are no seat belts or foreign objects near or around the ISOFIX/LATCH
*1
child-restraint system:
Not following the child-restraint system manufacturer's instructions when installing the
child-restraint system is dangerous. If seat belts or a foreign object prevent the child-restraint
system from being securely attached to the ISOFIX/LATCH
*1
lower anchors and the
child-restraint system is installed improperly, the child-restraint system could move in a
sudden stop or collision causing serious injury or death to the child or other occupants. When
installing the child-restraint system, make sure there are no seat belts or foreign objects near
or around the ISOFIX/LATCH
*1
lower anchors. Always follow the child-restraint system
manufacturer's instructions.
*
1 ISOFIX (Mexico)/LATCH (Except Mexico)
Installation on second-row outboard
seats
1. First, adjust the front seat to allow
clearance between the child-restraint
system and the front seat.
Refer to Adjusting the Driver's Seat on
page 2-5.
Refer to Adjusting the Front
Passenger's Seat on page 2-13.
2. Adjust the second-row seat position
using the following procedure.
Fold the second-row seatback
forward.
Raise the second-row seatback until
a click sound is heard and it is locked
in place.
3. Adjust the angle of the second-row
seatback so that there is no gap
between the child-restraint system and
the second-row seatback.
4. Make sure the seatback is securely
latched by pushing it back until it is
fully locked.
5. Remove the cover of the child-restraint
system's ISOFIX/LATCH
*1
lower
anchors to verify the locations of the
ISOFIX/LATCH
*1
lower anchors.
Lower anchor
Type A Type B
NOTE
The ISOFIX/LATCH
*1
lower
anchors marking on the cover
indicates the position of the ISOFIX/
LATCH
*1
lower anchors for the
attachment of a child-restraint
system.
Store the removed cover so that it
does not get lost.
Essential Safety Equipment
Child Restraint
2-65
CX-9_8JK1-EA-20G_Edition2_old 2020-7-20 17:31:45
To Next Page
Loading...
