Msintenance
t'"n,."!_.-
$\".,*
Ib
change coolant
(Manual
trans le)
I. Remove
the cooling system cap.
2. Only when
the engine is cool,loosen
the radiator drain
plug
and drain the
coolaflt into
a suitable container.
3.
With
the drain
plug
loose but not fully
removed, flush
out the system with
funning
waier.
4. Drain the sysi,em cornpletely and
retighten
the
plug.
Add as much
ethylene'glycol-based coolani and
water
as necessary to
provide
freezing
and corrosion
protection.
In extremely cold climates, add
the
amount recommended
in the coolant
manufacturer\ instruciions.
5. Run lhe engine
at
idle with
the cooling
system cap off. Slowly add additional
coolant ifnecessary,
6. At
this
point,
wait unlil the engine
reaches normal
operating tempenture;
then depress the accelerator
two or
three times. Add more coolant, if
necessary, until
lhe system
is
full.
7. Install the
cooling system cap. Inspect
all connections
for
leaks.
Inspect the
level
in dre coolant res€rvoir one more
Ib
change coolsnt
(Automatic
transaxle)
l Remove the cooling
system cap.
2. Only when the ergine is cool, remove
lhe radiator drain
plug
and drain the
coolant into a suitable container.
3. Flush out the system with running
8.22
To Next Page
Loading...
