3. Apply primer to the bonding area of the glass and the base.
CAUTION:
• Keep the area free of dirt and grease, and do not touch the surface. Otherwise, the primer may
not properly bond to the surface of the glass.
4. Apply a 3.0 mm {0.12 in} layer of sealant to the base.
NOTE:
• Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for
approx. 30 min .
5. Center the base in the ceramic coating and press it onto the glass.
6. Use isopropyl alcohol to remove any excess repair sealant.Hardening time of sealant
Temperature Surface hardening time Time required until vehicle can be put into service
5 °C {41 °F}
Approx. 1.5 h Approx. 12 h
20 °C {68 °F}
Approx. 1 h Approx. 4 h
35 °C {95 °F}
Approx. 10 min. Approx. 2 h
7. Install the rearview mirror.
To Next Page
Loading...
